Tp177 Micro Example Programs Using Opt
That is wrong nonuke! You can do exactly that with Prosave.The tricky part in this case is how to get the TP177-2PN/DP into Transfer mode, since the screen is damaged.(If you were to do a firmware update, there is a nifty function to set the option 'Reset to factory settings', which means you can connect prosave to the panel, start the OS Update, and then cycle power to the panel. When the panel boots up, prosave grabs control of it before the runtime application starts.Unfortunately, this function does not work with the regular backup or restore functions.)Manipk, first, look in the MMC card slot if the original programmer has been so kind as to leave the original program on a flash card in that slot. If he has, you can simply read the source file of the flash card.If you are not so lucky, you have to simply start the Backup, and hope that the panel was set to 'Remote Control'. You will know if the upload starts OK.edit: Try both ethernet and MPI/DP ports, as they can be set individually.
Tp177 Micro Example Programs Using Option
If one doesnt work it does not exclude the other.If the above does NOT work, your slim chance is that the touch function works even if the display does not. Use the other panel to figure out where the 'Transfer' button appears upon powerup, then press that area when powering up the defective panel.
Then start the Backup from Prosave.Good luck, and please accept my sympathy about the situation in your country. Hi Jesper,I have been using Siemens TP's for many years with Protool and with WinCC Flexible, and I could never upload a project from a TP to a PC, unless I have the original project already in the PC in a Protool, WinCC Flexible or Prosave format or I have the project in the TP Memory card (MMC).I didn't really understand the procedure you explained in the post, and it will be really nice to go to a TP with project from any supplier, and make a backup of the project, so if the TP breaks, we can download the project to a new one.
Tp177 Micro Example Programs Using Options
You can have an upload. It is a compiled upload, it's not the WinCC Flex project.Hi Jesper,I have been using Siemens TP's for many years with Protool and with WinCC Flexible, and I could never upload a project from a TP to a PC, unless I have the original project already in the PC in a Protool, WinCC Flexible or Prosave format or I have the project in the TP Memory card (MMC).I didn't really understand the procedure you explained in the post, and it will be really nice to go to a TP with project from any supplier, and make a backup of the project, so if the TP breaks, we can download the project to a new one.